If this is not sufficient, you can provide a username and password for the network resource in each profile.Also in order to enable access to a network drive, please try using a UNC path such as \\servername\sharename\foldername rather than a mapped drive letter.Windows Explorer should have already stored the password. Choose an account that has network access without Windows Explorer asking for a password for the network drive. Make sure that you specify a user account where you know that Windows Explorer has access to the volumes that you need. To change the log on account, please uninstall and then re-install the service. This is done when clicking on the Install… button on the Scheduler tab sheet to install the service. In order to access network drives, the service must be given a log on account.Then you will see the service-specific install/uninstall, start/stop buttons. If the “Background Scheduler” is running, please stop it and then choose Use: Service Scheduler. The service is installed and started from the Scheduler tab sheet of the main application window.This means that scheduled synchronizations take place without users having to log on. The scheduler can run as a Windows Service.The name of the service is the Syncovery Service. A user can also log out while the service is running a job. Service runs invisibly in the background without users noticing it. The service will start up automatically with Windows, even while no user has logged on yet. Running the scheduler as a service is a little more difficult to set up, but it has some advantages. This article applies only to Microsoft Windows.
0 Comments
Leave a Reply. |